All in stainless steel 18/10 AISI 304. The washing tunnels are composed of different modules, which allows disassembly for easy entry and then reassembly once in the workplace. The entire tunnel is made with double walls, including the guillotine doors, reducing noise and heat loss. The tubs are recessed, with rounded edges for easy cleaning. The additional modules include Pre-wash modules at an angle, Drying modules at an angle, Neutral intermediate modules, or Neutral entry zone modules, Detergent and Rinse Aid dispensers, etc. The filter consists of a flat and inclined surface for draining solid waste and a basket that collects it. Easily removable for emptying and cleaning. They allow an entry height of 450 mm for 500x500 baskets, enabling the washing of trays, GN containers, and other utensils. The basket drive is through lateral guides, which facilitate cleaning. The teeth that move the baskets are made of thick stainless steel. They are reversible, allowing for a change in entry or exit direction with simple operations. However, we recommend indicating the direction of movement when placing the order so it will come prepared from the factory. The speed of the basket advance is electronically regulated through a frequency variator and controlled from the control panel. Each pre-wash/wash/rinse and dry module starts and stops independently only if there is actually a basket inside, improving energy consumption. Control is through an electronic control panel with a multifunction screen, a 4-digit LED. It has 4 touch buttons to program all functions, provide information, select programs, etc. With USB connection. The recommended feed water temperature should ideally come from a heater at 40 to 60°C as the indicative production data is based on this range. If the water enters at 15 to 40°C, production will be lower and energy consumption higher. It also depends on whether you have a heat recovery module. It includes 2 baskets (multi-use and for dishes) and 1 cutlery container. With adjustable stainless steel legs, 200 mm. Prewash module with a length of 820 mm, equipped with a 70-liter tank and a washing system composed of 3 arms and 36 nozzles, with a 1.5 kW dual flow pump. Wash/rinse module with a length of 1150 mm, has a 70-liter tank, and a washing system with 5 arms and 60 nozzles, with a 2.7 kW dual flow pump. The temperature management system, with water heating or cooling, is electronically controlled. A constant supply pressure between 2 and 4 bar is necessary, installed after the wash/rinse process. It is 600 mm long and is at the height of the exit table. Manufactured with double walls, it operates at a low temperature of 65°C. It uses an air flow of 1400 m3/hour, extracted outside by a 550 W turbofan. The module is equipped with a drainage system.
